Industrial Bar Booth Seating, Leather Upholstered
Black on a tall back needs narrower channels, not wider ones. The same 70 mm that works at 950 mm turns into fluting at 1100.
| Type | Straight booth run, narrow channel back |
|---|---|
| Seat height | 450 mm standard · 430 / 470 mm on request |
| Seat depth | 500 mm standard · 460 / 540 mm on request |
| Back height | 1100 mm above floor |
| Back detail | 38 mm channels, 45 mm foam, full height |
| Upholstery | Black contract leather · any colour on request |
| Frame | Rubberwood, walnut stain, matt lacquer |
| Wall fixing | Concealed brackets · scribe allowance 20 mm each end |
| Packing | One crate per 2 m run |
| Terms | EXW Foshan or DDP to your address |
Trade enquiries only · EXW Foshan or DDP · replies inside three working days
Narrow channels on a tall back
Channel width has to be read against back height. At 950 mm, a 70 mm channel gives a back with six or seven divisions and the proportions hold. Stretch the same back to 1100 mm and those same 70 mm lines become long columns, and the piece starts to look like joinery rather than seating.
38 mm over an 1100 mm back gives the divisions a 1:29 ratio, close to what the eye reads as fabric rather than structure. The channels are also shallower in section, 45 mm of foam instead of 60, because a tall back does not need the same depth of padding behind the shoulder.
Walnut stain, black seat
Two dark materials will merge unless one of them has a texture. The stain here is a matt lacquer with the grain showing through, and the leather is a fine-grain pigment finish, so the eye separates them by surface rather than by colour.
Black leather that stays black is a matter of pigment, not dye. Pigment finishes sit on the surface and hold their depth; aniline black goes grey at the seat edge within a year.
Built as two halves over 2.4 m
Past 2.4 m the crate stops going through a service door. The run ships in numbered halves with the joint set behind a channel rather than through one, so the seam disappears into the pattern.
The joint is bolted through plates inside the carcass. Nothing is visible once the halves are together, and the seat foam is continuous across it.
Send a floor plan, get a priced layout back
Tell us the counter length, the number of covers and the look you want. We come back with stool counts, heights, finishes and a written quotation — usually inside three working days.