Metal frame chair, fabric seat and back
Slim tube and a padded back is the combination that lets a metal chair sit in a room that was specified around timber.
| Tube | Slim steel, powder coated |
|---|---|
| Back | Moulded shell, upholstered |
| Fixing | From the rear, cover replaceable |
| Frame | Metal |
| Cover | Fabric |
| Colours | To order |
| Terms | EXW Foshan or DDP to your address |
Trade enquiries only · EXW Foshan or DDP · replies inside three working days
Making steel look light
Steel chairs fail visually when the tube is too thick. Tube diameter decides it: 25 mm with a padded back reads as furniture, 32 mm with a flat seat reads as office furniture. The difference in cost between the two is small and the difference in how a room feels is not.
Frame colour does the rest. Powder coat matched to the bar front lets the chair disappear; a contrast colour makes the same chair a feature. Both are the same frame, so the decision can be made late.
Upholstery on a metal frame
Padded backs on steel need a shell between the foam and the tube, otherwise every contact point shows as a hard line through the cover. The shell here is a moulded panel rather than a board, so it follows the back's curve and spreads the load across the whole pad.
Fixing is from the rear, which keeps the front face clean and lets a cover be replaced without dismantling the frame.
Send a floor plan, get a priced layout back
Tell us the counter length, the number of covers and the look you want. We come back with stool counts, heights, finishes and a written quotation — usually inside three working days.